Reprogram a TP-Link Archer C20i

Follow these steps to reconnect your router and restore your internet connection.

1. Connect to the Router

You can connect using a cable (recommended) or Wi-Fi.

Option A: Wired (recommended)

1. Plug an Ethernet cable into one of the yellow LAN ports on the router.
   
2. Plug the other end into your computer.

Option B: Wi-Fi (if no cable available)

1. Check the sticker on the bottom of the router.
   
2. The default Wi-Fi name starts with TP-Link_.
   
3. Open Wi-Fi settings on your device.
   
4. Select TP-Link_xxxxx (numbers/letters vary).
   
5. Enter the 8-digit PIN shown on the router sticker.

You will be connected to the router but not to the internet yet.

2. Log In to the Router

1. Open a web browser.
   
2. In the address bar, type:
   • 192.168.0.1
     
3. Press ENTER.
   
4. Enter:
   • Username: admin
   • Password: admin
     
5. Click LOGIN.

3. Set Up the Internet Connection

1. Click NETWORK.
   
2. Select WAN.
   
3. Set Connection Type to PPPoE.
   
4. Enter:
   • PPP Username: your account number
   • PPP Password: your PPPoE password
     
5. Leave all other settings as default.
   
6. Click SAVE.

4. Enable Remote Management (Vfast Support Access)

1. Click SECURITY.
   
2. Select REMOTE MANAGEMENT.
   
3. Enter:
   • Web Management Port: 80
   • Remote Management IP Address: 80.88.192.113
     
4. Click SAVE.

5. Set Up Your Wi-Fi Networks

2.4 GHz Wi-Fi

1. Click WIRELESS 2.4GHz.
   
2. Select BASIC SETTINGS.
   
3. In Wireless Network Name, enter:
   • VFAST followed by the account holder’s initials.
     Example: Joe Bloggs = VFAST JB
     
4. Click SAVE.

5 GHz Wi-Fi

1. Click WIRELESS 5GHz.
   
2. Select BASIC SETTINGS.
   
3. Enter the same name as above and add 5GHz.
   Example: VFAST JB 5GHz
   
4. Click SAVE.

If you are connected over Wi-Fi, reconnect to the new Wi-Fi name.

6. Test Your Connection

1. Open a new browser tab.
   
2. Visit vfast.co.uk or another website.
   
3. If the page loads, your connection is working.

Need Help?

If your router does not connect after following these steps, contact the Service Desk:

support@vfast.co.uk