Reprogram a TP-Link WR940n

Follow these steps to reconnect your router and restore your internet connection.

1. Connect to the Router

You can connect using a cable (recommended) or Wi-Fi.

Option A: Wired (recommended)

1. Plug an Ethernet cable into one of the yellow LAN ports on the router.
   
2. Plug the other end into your computer.

Option B: Wi-Fi (if no cable available)

1. Check the sticker on the bottom of the router.
   
2. The default Wi-Fi name starts with TP-Link_.
   
3. Open Wi-Fi settings on your device.
   
4. Select TP-Link_xxxxx (numbers/letters vary).
   
5. Enter the 8-digit PIN shown on the router sticker.

You will be connected to the router but not to the internet yet.

2. Log In to the Router

1. Open a web browser.
   
2. In the address bar, type:
   • 192.168.0.1
     
3. Press ENTER.
   
4. Enter:
   • Username: admin
   • Password: admin
     
5. Click LOGIN.

3. Set Up the Internet Connection

1. Click NETWORK.
   
2. Select WAN.
   
3. Set WAN Connection Type to PPPoE / Russia PPPoE.
   
4. Enter:
   • Username: your account number
   • Password: your PPPoE Password
     
5. Click SAVE.

4. Enable Remote Management (Vfast Support Access)

1. Click SECURITY.
   
2. Select REMOTE MANAGEMENT.
   
3. Set:
   • Port: 80
   • Remote Management IP Address: 80.88.192.113
     
4. Click SAVE.

5. Change the Router Login Password

1. Click SYSTEM TOOLS.
   
2. Select PASSWORD.
   
3. Enter:
   1. Old Username: admin
   2. Old Password: admin
   3. New Username: admin
   4. New Password: account holder’s first initial and surname with 1 at the end (lowercase)
      Example: Joe Bloggs = jbloggs1
      
4. Click SAVE.

6. Set Up Your Wi-Fi Name (SSID)

1. Click WIRELESS.
   
2. Select WIRELESS SETTINGS.
   
3. In Wireless Network Name, enter:
   • VFAST followed by the account holder’s initials
     Example: Joe Bloggs = VFAST JB
     
4. Click SAVE.

If you are connected over Wi-Fi, reconnect to the new Wi-Fi name.

7. Test Your Connection

1. Open a new browser tab.
   
2. Visit vfast.co.uk or another website.
   
3. If the page loads, your connection is working.

Need Help?

If the router does not connect after following these steps, contact the Service Desk:

support@vfast.co.uk